Mounting The Wall Bracket - Muller licht tint 404028 Mode D'emploi

Mounting the wall bracket

1. Remove the protective film from both sticky pads.
2. Press the bracket with some force against a clean, dry and dust-free
surface.
Screwing in the wall bracket
Depending on the surface, the wall bracket can be attached to the wall
with screws and wall plugs if required. Screws and wall plugs are inclu-
ded with the bracket.
ATTENTION!
Make sure there are no pipes or wires in the wall where you intend to drill.
1. Separate the two halves of the bracket. (fig. 1)
2. Use the rear of the bracket as a stencil to mark where you will drill.
3. Drill the holes and insert the wall plugs (if needed) in the holes. (fig. 2)
4. Screw the rear of the bracket onto the wall.
5. Place the upper part of the bracket on the screwed lower part. (fig. 3)
The bracket can now be used.
fig. 1 fig. 2 fig. 3
tint-LED-PANEL
INSTRUCTION MANUAL
60