Muller licht Tint Mode D'emploi page 66

applicable. If this does not occur, switch the tint product
off and on again 6 times.
2. Press the group button repeatedly until all the LEDs
above the group button light up.
3. Hold the tint remote control very close (< 5 cm) to the
new tint product.
4. Hold down the group button until the tint product begins
to blink. The feedback display will first blink red evenly;
then, it will begin to blink more quickly. This means that
the tint remote control has found a signal.
The new tint product will then blink 3 times and show that
it has connected to the tint remote control. Keep holding
down the group button until the tint product blinks again
one time, which shows that it has been assigned to de-
fault group(=group 1).
5. If desired, you can select a different group by repeatedly
pressing the group button (middle LED = group 2 etc.).
After approx. 10 seconds, the new tint product will be
added to the selected group and the feedback display will
stop blinking. Wait this long, not pressing any buttons
during this time.
The procedure will then end and you can use the extend-
ed group as normal.
66 ENGLISH