Muller licht Tint Mode D'emploi page 67

Remove a tint product from the tint remote control
1. Switch the tint product off (i.e. to standby) with the tint
remote control if necessary.
2. Select the group you would like to change using the group
button.
3. Hold down the group button for approx. 5 seconds. The
feedback display will blink red/green.
4. Select the desired tint product by pressing the group
button repeatedly. The tint product will signal that it has
been selected by increasing and decreasing its bright-
ness. The tint product will blink in the order in which they
are stored in the tint remote control.
5. Hold down the standby button for approx. 5 seconds. The
tint product will then signal that it has been removed
from the tint remote control
by flashing and then dimming.
Add a tint product from one group into another group
1. Switch the tint product off (i.e. to standby) with the tint
remote control if necessary.
2. Select the group you would like to change using the
group button. (If you would like to add a tint product from
group 2 to group 1, for example, press the group button
repeatedly until the middle LED above the group button
lights up).
3. Hold down the group button for approx. 5 seconds. The
feedback display will blink red/green.
4. Select the desired tint product by pressing the group but-
ton repeatedly. The tint product will signal that it has been
selected by increasing and decreasing its brightness.
GROUP FUNCTIONS 67