Muller licht Tint Mode D'emploi page 69

Resetting the tint remote control
A reset is only necessary in exceptional cases, for example if
the tint products do not respond to the tint remote control even
after removing and reinserting the batteries.
NOTICE!
Resetting the remote control will delete all pre-defined
group settings and you will have to connect the tint remote
control and the tint products again afterwards.
1. Remove the battery compartment cover.
2. Use a pointed object to press the reset button on the back
of the remote control for three seconds, until the control
LED starts flashing. Wait until it stopped flashing again.
3. Then, proceed as described in the section "Resetting the
tint tint product" and then as described in the section
"Adding a new tint product". Each tint product will then
have to be connected individually one after the other. If,
for example, three tint products belong to one group, you
must repeat the steps in "Adding a new tint product" 3
times.
Incorporating in a Zigbee gateway
Generally, a tint product can only be connected with a re-
mote control or with a Smart Home System. In some Smart
Home systems with Zigbee, the tint remote control can
also be incorporated so that the tint products can then be
controlled via remote control or a Smart Home app or voice
controller at the same time. For instructions and additional
information, go to www.mueller-licht.de/tint
RESET 69