Setup; Inserting The Batteries - Muller licht Tint Mode D'emploi

SETUP

Inserting the batteries

1. Open the battery compartment at the rear of the tint
remote control.
2. Insert 1 CR 2450 / 3 V battery as shown on the bottom of
the battery compartment. Ensure the correct polarity of
the battery (+/-).
3. Close the battery compartment cover again.
Using the wall bracket (optional)
You can use the wall bracket (supplied) to store the tint
remote control safely. A magnet in the bracket will hold the
tint remote control safely in the bracket.
The bracket can be mounted on a surface of your choice
with adhesive strips or screws and wall plugs if required.
The bracket will still attract metal objects, even without any
adhesive or screws.
60 ENGLISH