Technical Specifications; Assembly And Adjustments - Haussmann Xpert MJ10250IXA Guide De L'utilisateur

UNPACKING
WARNING: If any part is missing or damaged, do not plug in the table saw until
you have replaced the missing or damaged parts.
!
To avoid injury, the styrofoam block should be removed between the motor and
the table.
If any parts are missing or damaged, please contact Customer service at
1-866-206-0888.

TECHNICAL SPECIFICATIONS

Code
Model
Capacity with 10" Blade:
Depth of cut at 90°
Maximum tilt angle of arbor (left)
Depth of cut at 45°
Max. cut right of blade with rip fence
Saw Dimensions:
Cabinet depth
Cabinet width
Cabinet length
Main table
Right extension table
Rear extension table
Saw blade:
Blade max. capacity
Blade arbor
Dado blade max. capacity
Saw Constructions:
Cabinet
Table
Rip fence
Drive system
Mitre gauge
Blade guard
Motor
No load speed
Net weight

ASSEMBLY AND ADJUSTMENTS

WARNING: DO NOT CONNECT THE PLUG TO THE OUTLET UNTIL ALL
INSTALLATIONS AND ADJUSTMENTS HAVE BEEN COMPLETED AND YOU
!
HAVE READ AND UNDERSTOOD THE SAFETY AND OPERATIONAL
INSTRUCTIONS.
ASSEMBLE THE STAND (fig. 1-6)
• Unpack all of the parts, and group them by type and size. Refer to the parts list
for correct quantities. (See Fig. 1)
• Attach the tubes of the stand assembly (B) with the corresponding tubes of the
97925002
MJ10250IXA
3-1/8" (8 cm)
45°
2-5/32" (5.5 cm)
24-1/2" (62.2 cm)
11-13/32" (29 cm)
20-3/4" (52.7 cm)
25-15/32" (64.7 cm)
24 x 21-1/16" (61 x 53.5 cm)
5-63/64 x 21-1/16" (15.2 x 53.5 cm)
24 x 2-35/64" (61 x 6.5 cm)
10" (25.4 cm)
5/8" (1.59 cm)
1/2" (1.3 cm)
Plastic
Cast aluminum
Aluminum extrusion
By gear
Cast aluminium with T-slot roller guide
Acrylic with anti-kickback pawls
120 V, 15 A, 60 Hz
4500RPM
81.4 lbs (37 kg)
43