Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6
7
8
fig.35
90
o
1
fig.36
3
1
fig.37
1
fig.38
ASSEMBLY AND ADJUSTMENTS
ADJUSTING THE RIP FENCE INDICATOR (FIG.35)
• The rip fence indicator (6) points to the measurement scale (8). The scale shows
the distance from the side of the fence closest to blade.
• Measure the actual distance with a ruler. If there is a difference between
the measurement and the indicator, adjust the indicator (6).
• Loosen the screw (7), and slide the indicator to the correct measurement on the
scale. Tighten the screw, and re-measure with ruler.
ADJUSTING THE MITRE GAUGE (FIG.36)
• Loosen the lock handle (1) in order to allow the mitre body (2) to rotate freely.
Position the mitre body at 90
Tighten the lock handle in order to hold the mitre body in position.
• If the pointer (3) requires adjustment, loosen the two screws under the pointer
using a hex wrench. Adjust the pointer to 90
tighten both adjusting screws.
• To change angles on the mitre gauge, loosen the lock handle (1) and rotate the
mitre body to the desire angle, as indicated by the scale. Secure in position by
tightening the lock handle.
ADJUSTING THE 90
This saw has positive stops that will quickly position the saw blade at 90
table. Make adjustments only if necessary.
90
STOP (FIG. 37)
O
• Raise the blade to the maximum height by turning the control handle counter
-clockwise.
• Loosen the bevel angle locking knob.
2
• Tilt the blade to the 90
• Using a square (1), verify that the blade is at a 90
• If blade is not at a 90
• Loosen the bevel locking knob and square the blade 90
• Once the blade is at a 90
locking knob.
• Carefully tighten the adjusting screw (2) until it touches the bevel stop.
DO NOT OVERTIGHTEN.
• Verify that the blade is still aligned at 90
45
STOP (FIG. 38)
2
O
• Raise the blade to the maximum height by turning the control handle
counter-clockwise.
• Loosen the bevel angle locking knob.
• Tilt the blade to the 45
• Using a square (1), verify that the blade is at a 45
• If blade is not at a 45
• Loosen the bevel locking knob and set the blade at a 45
• Once the blade is at a 45
knob.
• Carefully tighten the adjusting screw (2) until it touches the bevel stop.
DO NOT OVERTIGHTEN.
• Verify that the blade is still aligned at 45
2
, so that the positive detent secures its position.
o
AND 45
POSITIVE STOPS (FIG. 37-38)
O
O
(0
) bevel.
o
o
(0
) angle to the table, loosen the adjustment screw (2).
o
o
(0
) angle to the table top, tighten the bevel angle
o
o
(0
).
o
o
o
bevel.
angle to the table, loosen the adjustment screw (2).
o
angle to the table top, tighten the bevel angle locking
o
.
o
o
on the scale, and then firmly
o
o
(0
o
) angle to the table top.
(0
) to the table.
o
o
angle to the table top.
o
angle to the table.
o
to the
53
Publicité
Chapitres
Table des Matières
Dépannage
