Haussmann Xpert MJ10250IXA Guide De L'utilisateur page 46

fig.5
fig.6
fig.7
Knob
nut
Leveling food
fig.8
ASSEMBLY AND ADJUSTMENTS
ATTACH THE TABLE SAW TO THE STAND (Fig. 7)
WARNING: DO NOT OPERATE THIS MACHINE ON THE FLOOR. THIS IS A
VERY DANGEROUS POSITION.
• Place the stand on a level surface and level the stand to the floor.
• Place the table saw on top of the stand, aliging the holes in the base with the holes
in the stand.
• Place the flat washer before insert four hex bolts through the holes in the base and
the stand.
• Tighten all four bolts with hex key.
NOTE: DO NOT OVER-TIGHTEN THE NUTS THAT HOLD THE SAW TO THE
STAND. DOING SO WILL DAMAGE THE SAW BASE.
TO SECURE/LEVEL THE TABLE SAW (Fig. 8)
With the stand open and the table saw resting on a flat, level surface, the table
saw should not move or rock from side to side.
If the table saw rocks from side to side, the leveling food need adjusting until the
stand is balanced.
• Loosen the knob counterclockwise.
• Lift the table saw slightly so that you may turn the leveling foot until the stand no
longer rocks.
• Turning clockwise will lower the foot.
• Turning counterclockwise will raise the foot.
NOTE: Only the leveling foot with nut can be adjusted for height.
45