Haussmann Xpert MJ10250IXA Guide De L'utilisateur page 45

ASSEMBLY AND ADJUSTMENTS
stand assembly (A) and align the holes. (See Fig. 2)
• Place the flat washer M8 (M), leveling foot (K) before insert the bolt M8 x 60 (L)
into hole and put the flat washer M8 (M) on the opposite to the tube, then tighten
the knob (F) with hex key tightening the bolt (L). (See Fig. 3)
• Insert the bolt with leveling foot (D) into hole, and put flat washer M8 (M) on the
opposite tube, then tighten the knob (F), and you can See Fig. 4.
• Slide the flat washer M10 (G), roller sleeves (E), wheels (C), and flat washer M8
(H) and nut M8 (J) onto the axle through the hole in the center of the wheel as
illustrated. Secure in place using the wrench. (See Fig. 5)
• Repeat with the second wheel.
Figure 6 is completed stand assembly.
NOTE: Verity that the stand is securely locked in an open position and that the
shock abroption pad stabilized the table saw before operation.
44
A B
D E
G H
C
fig.1
K L
fig.2
fig.3
fig.4
F
J
M