Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GENERAL SAFETY GUIDELINES
the saw blade.
36. Clean the working area and the workpiece after each cut.
WARNING: Switch the tool off, remove the plug from the power socket and let
!
the machine come to a standstill. No foreign bodies are allowed to be on the
workpiece or the machine table. Cut pieces of the workpiece can be caught by
the rotating cutting disc and be flung away.
37. Never reach into the openings of the table saw. Never insert objects into
the openings of the tool (e.g. the saw blade casing, dust extraction
adaptor). Danger of cuts.
38. Never remove the cutting piece if the machine is still switched on
or running. Danger of cutting yourself.
39. Cut workpieces may have sharp edges, ridges or wooden splinters.
Danger of cutting injuries.
40. Always switch the machine off and remove the power plug when your
leave the machine.
41. Never expose the tool to rain or extreme moisture.
42. Do not perform any cuts with this table saw, other than those
described in these operating instructions! Seams and notches are not
allowed to be sawn.
43. This table saw cannot to be used for slitting (notches which end in the
workpiece).
ELECTRICAL INFORMATION
GUIDELINES FOR USING EXTENSION CORDS
WARNING: THIS TABLE SAW IS INTENDED FOR INDOOR USE ONLY. DO
!
NOT EXPOSE IT TO RAIN OR USE IT IN DAMP LOCATIONS.
Make sure the extension cord is in good condition. When using an extension cord,
be sure to use one that is heavy enough to carry the current that your product will
draw. An undersized cord will cause a drop in line voltage, which will result in loss
of power and overheating. The table below shows the correct size to be used
according to cord length and nameplate ampere rating. When in doubt, use the next
heavier gauge. The smaller the gauge number, the heavier the cord.
Ampere Rating
More Than
10
12
Make sure your extension cord is properly wired and in good condition. Always
replace a damaged extension cord, or have it repaired by a qualified person before
using it. Protect your extension cords from sharp objects, excessive heat, and
damp or wet areas.
MINIMUM GAUGE FOR EXTENSION CORDS (AWG)
(when using 120 V only)
Not More Than
25' (7.6 m)
0
6
6
10
12
16
Total length of cord in feet (metres)
50' (15.2 m)
100' (30.5 m)
18
16
18
16
16
16
Not Recommended
14
12
150' (45.7 m)
16
14
14
12
14
12
41
Publicité
Chapitres
Table des Matières
Dépannage
