Haussmann Xpert MJ10250IXA Guide De L'utilisateur page 41

GENERAL SAFETY GUIDELINES
you are able to work better and safer with it. Observe the guidelines on
lubrication and exchanging the tool. Check the power cable of the power
tool regularly and in case of damage let a recognized specialist repair it.
Check extension cables regularly and replace them if they are damaged.
Keep the handles dry, clean and free of oil and grease.
19. Pull the plug out of the power socket when the electric power tool is not
in use, before maintenance and when exchanging tools such as saw blades,
drills and mills.
20. Do not leave keys in the table saw. Before you switch the tool off, check
that keys and setting tools have been removed.
21. Avoid starting-up the tool accidentally. Make sure that when you insert
the plug into the power socket, the power switch is turned off.
22. Only use extension cords with proper gauge and voltage. See chart on
next page.
23. Be attentive. Be careful what you do. Carry out your work sensibly.
24. Check the power tool for any sign of damage. Before continuing work
with power tool, safety devices or easily damaged parts have to be
carefully checked to ensure that they function properly and are not
defective. Check that the moving parts are working properly and are not
jammed, or whether the parts are damaged. All parts must be correctly
assembled by an experienced individual, unless stated otherwise in the
operating instructions, and meet all required conditions in order to
guarantee that the power tool functions without a problem. Damaged
switches have to be replaced by a qualified electrician. Do not use
power tools if the power switch cannot be turned on and off.
25. WARNING!
The use of other insertion tools and accessories can present a danger of
injury to you.
26. Let a qualified electrician repai r your power tool. This power tool
corresponds to the applicable safety conditions. Repairs are only allowed
to be carried out by an electrician, using original replacement parts;
otherwise accidents may occur.
ADDITIONAL SAFETY GUIDELINES FOR TABLE SAWS
27. No other people are allowed to stand in the direct vicinity of the machine
when it is in use. People not operating the machine must maintain a suitable
safe distance.
28. Never lay the power cable over the saw table.
29. Use the push rod to pass the workpiece safely into the saw blade. Do not
come too close to the saw blade.
30. Make sure that the thickness of the material to be cut is less than
the maximum possible cutting depth.
31. Never cut "hands-free". The workpiece must always lie level on the
machine table and be moved along the stop! The workpiece must always
be pressed hard against the stop.
32. Never cut workpieces that are so small that they cannot be safety pressed
against the stop and could turn.
33. Never cut workpieces that are so small that they cannot be moved by the
push rod at a safe distance from the saw blade.
34. Only cut one workpiece at a time. Never cut several workpieces
simultaneously. Workpiece are not allowed to be placed behind or on top
of each other. There is a danger of the workpiece "jamming" and slipping
away.
35. Make sure that the workpiece cannot slip while cutting or get jammed in
40