Haussmann Xpert MJ10250IXA Guide De L'utilisateur page 50

Screw
fig.19
1
fig.20
6
4
3
5
fig.21
7
fig.22
ASSEMBLY AND ADJUSTMENTS
TO REMOVE/REPLACE/ALIGN THE TABLE INSERT (Fig. 19)
WARNING: The table insert must be level with the saw table. If the table insert is
too high or too low, the workpiece can catch on the uneven edges resulting in
binding or kickback which could result in serious personal injury.
Lower the blade by:
1) Unlock the blade heigh lock knob (turn counterclockwise).
2) Turn the height adjusting knob counterclockwise to lower the blade.
• To remove the table insert: place your index in the hole and lift the front end pulling
the table insert out toward the front of the saw.
• To reinstall the table insert: slip the tab into the slot at the back of the saw and push
down to secure in place.
Using a hex key, adjust the six set screws until the table insert is level with the
saw blade.
INSTALL THE BLADE TO THE ARBOR (Fig. 20-22)
WARNING: TO AVOID INJURY FROM AN ACCIDENTAL STARTUP, VERIFY
THAT THE SWITCH IS IN THE "OFF" POSITION AND THE PLUG IS NOT
CONNECTED TO THE OUTLET. IN ORDER TO AVOID SERIOUS INJURY, THE
TABLE INSERT MUST BE LEVEL WITH THE TABLE.
NOTE: KEEP THIS MANUAL AS REFERENCE FOR FUTURE BLADE CHANGES.
• Remove the table insert (1) by inserting the finger into the hole (2) (see Fig. 20).
2
• Raise the saw blade arbor (3) to its maximum height by turning the blade raising
hand wheel counter-clockwise. Remove the arbor nut (4) and the outer flange (5)
from the saw arbor. (see Fig. 21)
• Place the saw blade on the arbor, making sure the teeth of the blade point DOWN
at the front of the table.
• Place the flange (5) and the arbor nut (4) on the arbor, and tighten the nut as far
as possible by hand, making sure the saw blade is firmly seated against the inner
flange (6) (see Fig. 20).
NOTE: Make sure the large flat surfaces of the flange and the nut face INWARD,
toward the saw blade.
• Place the jaws of the open-ended wrench (7) on the flats of the flange (5) in order
to prevent the arbor from turning while tightening. Tighten the arbor nut by turning
it clockwise using the open-ended wrench (7) (See Fig. 22).
WARNING: MAKE SURE THE SAW BLADE, ARBOR FLANGE, AND NUT ARE
PROPERLY SEATED, AND VERIFY THAT THE ARBOR NUT IS TIGHT.
49