Electrical Connections; Extension Cords; Horsepowert (Maxmum Developed); Voltage - Haussmann Xpert 5848006 Manuel De L'utilisateur

• A 2-prong wall receptacle must be replaced with a
properly grounded 3-prong receptacle installed in
accordance with National Electric Code and local codes
and ordinances.

EXTENSION CORDS

• The use of any extension cord will cause some drop in
voltage and loss of power.
• Wires of the extension cord must be of sufficient size to
carry the current and maintain adequate voltage.
• The minimum extension cord wire size is A.W.G. 14.
Do not use extension cords over 25 feet long.
• Use only 3-wire extension cords having 3-prong
grounding type plugs and 3-pole receptacles which
accept the tool plug.
• If the extension cord is worn, cut or damaged in any
way, replace it immediately.
MOTOR
Planer is supplied with a 2.4 HP motor installed.
The 120 Volt AC universal motor has the following
specifications:
Horsepower (Maximum Developed) . . . . . . . . . . . . 2.4 HP

Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .120

Amperes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15

Hertz. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60

Phase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Single

Cutterhead RPM . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8,000

ELECTRICAL CONNECTIONS

WARNING
Make sure unit is turned off and disconnected from power
source before inspecting any wiring.
The motor is installed and wiring connected as illustrated
in the wiring schematic (see Figure 7).
Figure 7 - Wiring Schematic
The motor is assembled with an approved three conductor
cord to be used on 120 volts as indicated. The power
supply to the motor is controlled by a double pole locking
switch.
The power lines are connected directly to the switch.
The green ground line must remain securely fastened
to the frame to properly protect against electrical shock.
A manual reset overload protector is installed in line with
the power supply to the motor. If the planer is overloaded,
the protector will break the circuit.
23