Tempo Fitness 612T Manuel Du Propriétaire page 10

TOOLS INCLUDED:
4 mm Allen Wrench
5 mm L-Wrench/Screwdriver
6 mm T-Wrench
ALL
PARTS INCLUDED:
MODELS
1 Safety Key
1 Console Assembly
2 Console Masts
2 End Caps
612T: 2 Handlebars
612T: 4 Hardware Bags
622T: 5 Hardware Bags
622T: 2 Frame Extension Tubes
1 Bottle of Silicone Lubricant
(for 2 applications)
French Overlays
NEED HELP?
If you have questions or if
there are any missing parts,
contact Customer Tech
Support. Contact information
is located on the back panel
of this manual.
10
PRE ASSEMBLY
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a
protective covering on your floor. Take CAUTION when handling and transporting this
unit. Never open box when it is on its side. Once the banding straps have been removed,
do not lift or transport this unit unless it is fully assembled and in the upright folded
position, with the lock latch secure. Unpack the unit where it will be used. Never grab
hold of any portion of the incline frame and attempt to lift or move the treadmill.
WARNING
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any grease,
such as lithium bike grease is recommended.