JVC GY-DV300 Manuel D'instructions page 77

2. Adjusting the Audio Recording Level Manually
● The standard level for recording
audio on the tape is –12 dB.
If a tape recorded on the GY-
DV300 is played back on VCR
whose audio standard level is –
20dB, the sound will be very
loud.
If a tape recorded on other VCR
whose audio standard level is
–20dB is played back on GY-
DV300, the sound will be very
low.
The audio level meter is displayed
by setting the AUDIO LEVEL item
on the DISPLAY [2/2] menu screen
to ON.
Reducing the Wind Noise of the Microphone
SYSTEM [1/2] menu screen
E M 1 / 2 ] [
SY S T
M I C 1 I NP U T S E L
W I N D C U T M I C 1
W I N D C U T M I C 2
+ 4 8 V M I C 1
+ 4 8 V M I C 2
A UD I O MOD E
R E C MOD E
LONG P A US E T I ME 3 0 M I N
N E X T P AG E
PAG E B A CK
1.
Turn the AUDIO LEVEL controls.
The audio recording level of CH-1 channel is adjusted with the
CH-1 AUDIO LEVEL control, and the CH-2 channel is adjusted
with the CH-2 AUDIO LEVEL control.
The recording level is raised when the control is turned clockwise.
● Adjust the level while observing the audio level meter on the
To return to the automatic audio recording level adjustment
mode, use either of the following methods.
● Set the CH1 AUDIO LEVEL or CH2 AUDIO LEVEL item on the
OPERATION menu screen to AUTO
or
● Set the MODE item to AUTO on the TOP MENU screen.
In this case the shooting mode becomes the auto mode.
Set the WIND CUT MIC1 or WIND CUT MIC2 item on the SYSTEM
[1/2] menu screen to ON.
I T N
ON
WIND CUT MIC1
ON
OF F
OF F
4 8 K
S P
WIND CUT MIC2
LCD screen or the viewfinder screen and/or monitoring the
sound.
The monitor sound is output from the EARPHONE jack (
See page 51.)
Set to ON to reduce the wind noise of the
built-in microphone or a microphone
connected to the MIC 1 input connector.
Set to ON to reduce the wind noise of a
microphone connected to the MIC 2 input
connector.
CH-1
AUDIO
LEVEL
AUDIO LEVEL
controls
CH-2
E-77