Power Supply Preparation; Ac Operation - JVC GY-DV300 Manuel D'instructions

PREPARATIONS
The GY-DV300 is operable with AC power supply or battery pack.

AC Operation

Use the optional AC Adapter/Charger AA-P30 as the AC power supply.
The DC INPUT connector on the GY-DV300 accepts power voltage in the range of DC 6V to DC 12V.
Set the POWER switch on the GY-DV300 to OFF.
If a battery pack is attached to the unit, detach the battery pack.
1.
Plug one end of the DC cable provided with the AC Adapter/Charger into the DC INPUT connector of
the GY-DV300, and then connect the other end to the DC OUTPUT connector on the AC Adapter/
Charger.
2.
Plug the AC cable of the AC Adapter/Charger into an AC outlet. The POWER lamp illuminates when
power is supplied to the AC Adapter/Charger.
* For details, see the instruction manual for the AA-P30.
CAUTION:
• Do not disconnect or connect the DC cable or AC cord while recording is taking place.
• Remaining battery power indication when the AC adapter is used
When the optional Network Pack KA-DV300 is connected, the remaining battery
power indication for fully charged battery may not be displayed.
Fully charged

Power Supply Preparation

POWER switch
DC INPUT
connector
DC cable
POWER lamp
To AC outlet
AC cord
AA-P30
DC OUTPUT
connector
E-33