Front Section - JVC GY-DV300 Manuel D'instructions

CONTROLS,
INDICATORS AND CONNECTORS
]
`
\ Built-in microphone
Built-in monaural microphone.
● To use this microphone, set the MIC INPUT
SEL item to INT on the SYSTEM [1/2] menu
screen.
] [MIC 1] Microphone 1 input connector (XLR-
3P)
Connect an external microphone to this
connector. Monaural signals are recorded.
● To use the microphone connected to this
connector, set the MIC1 INPUT SEL item to
XLR on the SYSTEM [1/2] menu screen.
● To use a microphone requiring +48 V power
supply (phantom microphone), set the +48V
MIC1 item on the SYSTEM [1/2] menu screen
to ON. This connector will then supply +48 V
DC current.
When using a microphone other than a
phantom microphone, set the +48V MIC1 item
to OFF.
E-20

Front Section

` [MIC 2] Microphone 2 input connector (XLR-
3P)
Connect an external microphone to this
connector. Monaural signals are recorded.
● To use a microphone requiring +48 V power
supply (phantom microphone), set the +48V
MIC2 item on the SYSTEM [1/2] menu screen
to ON. This connector will then supply +48 V
DC current.
When using a microphone other than a
phantom microphone, set the +48V MIC2 item
to OFF.
Memo:
• The audio input channel is selected with the
CH-1/CH-2 audio input selector switch M.
• To reduce the wind noise of the microphone,
set the WIND CUT MIC1/MIC2 item on the
SYSTEM [1/2] menu screen to ON.
\