Connecting The Power Supply - JVC KY-F560 Mode D'emploi

Connecting the Power Supply

Connect the [DC IN] terminal at the back of this unit to the [TO CAMERA] terminal of the AC adaptor (AA-
P700) using the power cable supplied (2 m).
AC 120 V
white marking to the AC
Plug
Caution
Ensure to make use of AA-P700 for the power supply.
When connecting, ensure that power switch of AA-P700 is turned OFF. Connecting with the power on may
give rise to malfunction of the equipment.
Note
Allow a 10 second interval after switching off the power before turning on again. If the power switch is turned
ON and OFF too soon, malfunctioning such as startup failure may occur.
AA-P700 AC Adaptor
DC 12V=OUTPUT
AC 100V
S(Y/C) OUTPUT
EITHER
OUTPUT
MAX 1.25A
White Marking
Connect the end with
adaptor.
D C I
N
Ring
VIDEO OUTPUT
TO CAMERA
SEE INST-
RUCTION
MANUAL
[TO CAMERA] Terminal
Power Cable (2 m)
(accessories)
● Insert plug fully, turn ring and ensure that it is fas-
tened.
Connect the plug in the same way at the AC adaptor's
end.
AW BARS
MENU SET
REMOTE LENS
VIDEO OUT
GENLOCK IN
DC IN
POWER
SEE INSTRUCTION MANUAL
[DC IN]
Terminal
E-15