Filter Cartridge Replacement - Pentair FreshPoint F2000-B2B Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION CONTINUED
A. Determine the length of plastic blue tubing needed to connect
to the outlet (right) side of the filter from the faucet. Be sure
to allow enough tubing to prevent kinking and cut the tubing
squarely. Use a marker to mark one end of the tubing 5/8" from
the end (Figure 5). Wet the end of the 3/8" tube and push into
the outlet (right) connection of the system up to the mark.
Do not bend or crimp tube inserting.
CAUTION
B. Gently pull back on the tube to ensure it is connected properly.
6. Connecting the Supply Adapter
A. Determine the length of plastic white tubing needed to connect
the inlet (left) side of the filter with the feed adapter installed
on the cold water supply line. Be sure to allow enough tubing to
prevent kinking and cut the tubing squarely. Place a mark 5/8"
from one end of the tubing. Wet the end of the tubing. Insert the
end of the tubing into the 3/8" fitting of the inlet supply adapter.
The 5/8" mark should be flush with the collar of the fitting
located on the inlet supply adapter (Figure 6a).
B. Mark the remaining end of the tubing. Use a marker to mark
5/8" from the end. Wet the end of the tube. Insert the end into
the feed connection on the inlet side (left) of the system. The
tube should go in up to the mark. (Figure 6b).
7. Placing the System into Operation
A. Slowly turn on the cold water supply. Ensure that the feed
adapter valve is also open.
B. Open faucet and flush filter for 10 minutes. Discard water.
C. Check for leaks at all fittings before leaving installation. If leaks
appear, see Troubleshooting.
NOTE: A drinking water cartridge may contain carbon fines
(very fine black powder). If carbon fines appear in
the water, discard water. More flushing is required if
carbon fines are present.
NOTE: Initially, filtered water may appear cloudy. If
cloudiness in a glass of water disappears from the
bottom; fine air bubbles are present. This air within
the water will disappear within a few weeks after
installation.
INSTALLATION IS NOW COMPLETE.

FILTER CARTRIDGE REPLACEMENT

NOTE: The life of the filter cartridges depends on water
volume used and the quality of the feed water. It is
6 • FRESHPOINT F2000-B2B, F2000-B2M Filtration Systems Instruction Manual
5
6b
7
6a

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Freshpoint f2000-b2m

Table des Matières