Performance Data; Filter Capacity - Pentair FreshPoint F2000-B2B Manuel D'installation Et D'utilisation

PERFORMANCE DATA

Important Notice: Read performance data and compare the
capabilities of the system with your actual water treatment
requirements. It is recommended that the supply water be tested,
before installing a water treatment system, to determine your water
treatment needs.
Test Conditions
Flow Rate
F2000-B2B = 0.60 gpm (2.27 L/min)
F2000-B2M = 0.60 gpm (2.27 L/min)

Filter Capacity

F2000-B2B = 675 gallons (2555 L)
F2000-B2M = 675 gallons (2555 L)
Inlet Pressure = 60 psi (4.1 bar)
Temperature = 68°F +/- 5°F (20°C+/- 2.5°F)
Testing was performed under standard laboratory conditions, actual
performance may vary.
Operating Requirements for F2000-B2B and F2000-B2M Systems:
Pressure = 40-100 psi (2.75-6.89 bar)
Temperature = 40-100°F (4.4–37.8°C)
Performance Data Sheet Reduction Claims
for Organic Chemicals Included by Surrogate Testing
Influent Challenge
Substance
Concentration mg/L
alachlor 0.050
atrazine 0.100
benzene 0.081
carbofuran 0.190
carbon tetrachloride 0.078
chlorobenzene 0.077
chloropicrin 0.015
2,4-D 0.110
dibromochloropropane (DBCP) 0.052
o-dichlorobenzene 0.080
p-dichlorobenzene 0.040
1,2-dichloroethane 0.088
1,1-dichloroethylene 0.083
cis-1,2-dichloroethylene 0.170
trans-1,2-dichloroethylene 0.086
1,2-dichloropropane 0.080
cis-1,3-dichloropropylene 0.079
dinoseb 0.170
endrin 0.053
ethylbenzene 0.088
ethylene dibromide (EDB) 0.044
haloacetonitriles (HAN):
bromochloroacentonitrile 0.022
dibromoacetonitrile 0.024
dichloroacetonitrile 0.0096
trichloroacetonitrile 0.015
haloketones (HK):
1,1-dichloro-2-propanone 0.0072
1,1,1-trichloro-2-propanone 0.0082
heptachlor 0.080
heptachlor epoxide 0.0107
hexachlorobutadiene 0.044
hexachlorocyclopentadiene 0.060
lindane 0.055
methoxychlor 0.050
pentachlorophenol 0.096
simazine 0.120
styrene 0.150
1,1,2,2-tetrachloroethane 0.081
tetrachloroethylene 0.081
toluene 0.078
2,4,5-TP(silvex) 0.270
tribromoacetic acid 0.042
1,2,4-trichlorobenzene 0.160
1,1,1-trichloroethane 0.084
1,1,2-trichloroethane 0.050
trichloroethylene 0.180
trihalomethanes (includes):
chloroform (surrogate
chemical)
bromoform 0.310
bromodichloromethane
chlorodibromomethane
xylenes (total) 0.070
10 • FRESHPOINT F2000-B2B, F2000-B2M Filtration Systems Instruction Manual
Maximum permissible Product
Water Concentration mg/L
0.001
0.003
0.001
0.01
0.0018
0.001
0.0002
0.0017
0.00002
0.001
0.001
0.0048
0.001
0.0005
0.001
0.001
0.001
0.0002
0.00059
0.001
0.00002
0.0005
0.0006
0.0002
0.0003
0.0001
0.0003
0.0004
0.0002
0.001
0.000002
0.00001
0.0001
0.001
0.004
0.0005
0.001
0.001
0.001
0.0016
0.001
0.0005
0.0046
0.0005
0.001
0.015
0.001
F2000-B2B, F2000-B2M SYSTEMS
INSTALLED WITH F2B2-RC2 FILTER
CARTRIDGE SET
This system has been tested according to NSF/ANSI 42 and 53 for
reduction of the substances listed below. The concentration of the
indicated substances in water entering the system was reduced to
a concentration less than or equal to the permissible limit for water
exiting the system, as specified in NSF/ANSI 42 and 53.
Conforms to NSF/ANSI 53 for VOC reduction. See performance data
sheet for individual contaminant and reduction performance.
Model F2000-B2B, F2000-B2M Systems
Influent Max. Permissible
Substance Challenge Product Water
Concentration
Standard 42
Chlorine Taste &
2.0 mg/L±10%
Odor
Particulates (0.5- at least 10,000
<1uM) Class 1* particulates/mL
Standard 53
Minimum
Cysts **
50,000/L
Atrazine 0.009 mg/L ± 10%
Lead (pH 6.5) 0.15 mg/L ± 10%
Lead (pH 8.5) 0.15 mg/L ± 10%
Lindane 0.002 mg/L ± 10%
Chloroform
(VOC surrogate 0.300mg/L ± 10%
chemical)
Perfluorooctanoic
Acid (PFOA) and
0. 0015mg/L ± 10%
Perfluorooctane
Sulfonate (PFOS)
Flow Rate = 0.6 gpm (2.2 L/min); Capacity = 675 gallons (2555 L) or 12
months
Testing was performed under standard laboratory conditions, actual
performance may vary.
* Reduces particles as small as 0.5-1 micron in size by mechanical means
** NSF/ANSI Standard 53 certified to reduce cysts such as Cryptosporidium
and Giardia by mechanical means.
The Models F2000-B2B and F2000-B2M are Tested and Certified by NSF
International against NSF/ANSI Standard 42, 53, and CSA B483.1 for the
reduction of substances specified on the Performance Data Sheet.
C US
EPA Est 082989-CHN-001
Reduction Minimum
Requirements Reduction
Concentration
≥50%
>85%
99.95% 99.97%
0.003 mg/L 90.5%
0.010 mg/L 99.3%
0.010 mg/L 99.3%
0.0002 mg/L 94.8%
0.015 mg/L 96.5%
0.00007 mg/L 96.27%
The models F2000-B2B and F2000-B2M are certified by IAPMO
R&T against NSF/ANSI 53 for the reduction of perfluorooctanoic
acid (PFOA) and perfluorooctane sulfonate (PFOS).
Average
Reduction
95.9%
97.9%
99.99%
93.7%
99.9%
99.6%
97.4%
98.8%
98.06%