CARTRIDGE TIMER PROCEDURE
FILTER CARTRIDGE TIMER
(MONITORED SYSTEMS ONLY)
The filter cartridge timer can be installed to the systems decorative
cover by peeling away the adhesive backing on the metal plate
included with the cartridge timer. The timer can also be attached to
a metal magnetic surface using the magnet that is factory installed
on cartridge timer.
INSTALLATION AND ACTIVATION
Once the installation location has been selected, activate the timer
by pulling the plastic tab out from the side of the timer. Press and
release the key to verify the battery is operational. The light will
blink green three times. (Figure 9a)
NOTE: The timer operates on 12 month schedule. The timer
uses a coin cell type 2023 battery.
The Filter Cartridge Timer is Operational
Operation
1. The timer will begin to blink red once every three minutes after
11 months, and will blink red three times every three minutes
after 12 months. (Figure 9b)
Timer status of the cartridge life can also be
NOTE:
viewed immediately by pressing and releasing the
key.
Reset Timer
1. To reset the timer after filter cartridge replacement, press the
key and hold for 5 seconds. The timer is now reset to 12 months.
(Figure 9c)
Battery Replacement
1. Replace the battery every 12 months. To replace the battery,
locate the slot on the side of the timer body and carefully
remove the front of the timer. The battery is now accessible.
(Figure 9d)
2. Slide the new battery under the battery retention bracket with
the positive + side of the battery facing up towards the battery
retention bracket. Align the tab on the timer back to the slot on
the timer front and press and snap both timer halves together.
Battery replacement will not reset the 12 month timer. If reset is
required, press and hold key for 5 seconds.
8 • FRESHPOINT F2000-B2B, F2000-B2M Filtration Systems Instruction Manual
9a
9b
9c
9d
Metal
Plate
Magnet
Blinks
Greeen 3x
Key
Blinks red 1x after 11 months
Blinks red 3x after 12 months
Press and hold for 5 seconds