Invacare Perfecto 2 Serie Manuel D'utilisation page 19

Your oxygen concentrator will perform best when operated
under the conditions outlined in the Typical Product
Parameters on page 14. Usage in environments other than
those described may result in the need for increased
equipment maintenance. The air intake of the unit should be
located in a well ventilated area to avoid airborne pollutants
and/or fumes.
Set Up
1. Plug in power cord to an electrical outlet.
2. Connect Humidifier (If So Prescribed)
DO NOT overfill humidifier.
DO NOT reverse the oxygen input and output connections.
Water from the humidifier bottle will travel through the
cannula back to the patient.
NOTE: For this procedure, refer to FIGURE 6.1, FIGURE 6.2 on
page 20, FIGURE 6.3 on page 21.
1. Remove cap from bottle.
2. Fill humidifier with distilled water to the level indicated
by the manufacturer. Replace the humidifier cap and
securely tighten.
Part No 1163146
SECTION 6—OPERATING INSTRUCTIONS
WARNING
Humidifier
Bottle with Cap
FIGURE 6.1 Filling the Humidifier
19
Humidifier
Bottle w/o Cap
Perfecto ™Series
2