Frigomat G20 02 Série Manuel D'utilisation Et D'entretien page 47

SANITIZING FIXED PARTS
While the removable parts soak in the sanitizer inside the tub, proceed sanitizing the fixed
parts of the machine:
SANITIZING THE CYLINDER
 Immerse a disposable paper cloth in the
sanitizing liquid.
 Pass the cloth over all the batch freezing
cylinder surfaces.
 Also pass the cloth over the visible
internal and external surfaces of the drain
pipe.
 Use the brush, previously immersed in the
sanitizing solution, to clan the OR seats
thoroughly, which are positioned on the
drain pipe.
 Also pass the cloth over the outer edge of
the cylinder until reaching the surfaces of
the upper cover, front panel hook block
and funnel.
SANITIZING DRIVE SHAFT
 Immerse a disposable paper cloth in the
sanitizing liquid.
 Pass a cloth over the entire surface of the
drive shaft positioned at the centre of the
batch freezing cylinder. Pay particular
attention to the drive gauge and the joint
on the bottom with the base of the batch
freezing cylinder.
ENGLISH - 22