Frigomat G20 02 Série Manuel D'utilisation Et D'entretien page 44

19 - ENGLISH
 Pour the maximum admitted load of cold drinking
water into the machine to rinse the surfaces which
were just treated with the sanitizer.
 Drain the rinse water and turn the machine off.
 When pre-washing is over, all the removable parts in
contact with the product must be disassembled and
sanitized in a separate tub.
SANITIZING REMOVABLE PARTS
PREPARATION OF WASHING TUB
 Wash your hands well and/or wear disposable
gloves.
 Fill a clean tub with a sufficient amount of drinking
water at approximately 50°C.
 Prepare the supplied brush and the OR disassembly
device and place them in the solution.
We suggest using the following sanitizing
solution:
Ecolab P3 Topax-san
(4% dilution = 200 ml every 5 litres of water).
REMOVING AND CLEANING COVER
 Slide the hinge pins out and remove the lid.
 Emerge the previously disassembled components
into the tub with the sanitizer and brush the surfaces
with care. Pay special attention to the surfaces in
direct contact with the product.