Frigomat G20 02 Série Manuel D'utilisation Et D'entretien page 36

 Operating temperature should be between 15° and 35°C.
 Humidity should be between 30 and 60%.
FRIGOMAT s.r.l. will not be held liable for personal harm and/or damage to objects
deriving from incorrect installation and/or by failure to comply with work accident-
prevention standards. Never intervene on the machine with your hands, neither during
normal operating cycles nor during cleaning and maintenance, without first having stopped
the machine by pressing the ON/OFF button and having turned off the master switch.
Never clean the appliance using a high-pressure water jet. Never shut the water cut-off
cock while the machine is running. Be careful never to damage the power cable. If so,
have it replaced.
Machines with water cooling which are left in places at a temperature below or close to
0°C, must first have all the water drained from the condenser.
11 - ENGLISH
2. Condensation
only).
With the machine in production mode, after a
few seconds condensation water must come
out of the drain pipe at a temperature of about
35°C. If this is not the case, the pressure switch
valve shown in the figure must be adjusted.
Three-phase machines are powered with three-
phase + neutral lines: be careful never to
connect the
FRIGOMAT will not be held liable for damage
to the machine deriving from non-compliance
with this rule.

Press the STOP button to stop the machine.
pressure (water
phase lines with
models
neutral.