Extraction - Frigomat G20 02 Série Manuel D'utilisation Et D'entretien

6.4 EXTRACTION

17 - ENGLISH
To extract the product at the end of a productive cycle,
refer to the following instructions:
- Position a cold and clean tub of adequate capacity on the
front shelf of the machine.
- Check that the production cycle has ended and the timer
is at position 0 for at least 30".
This simple action can prolong the life span of the
scrapers and safeguard the beater motor.
MODELS G20- G30
- Pull the dispensing lever up to open the dispensing
plate
- Rotate the selector clockwise on Pos.1 to release the
low speed extraction.
- Rotate the selector clockwise on Pos.2 to release the
high speed extraction. The compressor is OFF.
- After the extraction, rotate the selector onto 0, open the
lid and remove the eventual product residues with a
plastic spatula.
MODEL G60
- Pull the dispensing lever up to open the dispensing
plate
- Rotate the selector clockwise on Pos.1 to release the
low speed extraction.
Rotate the selector clockwise on Pos.2 to release the
high speed extraction. The compressor is OFF
During the extraction phase, by pushing the "continuous
cod" button, it is possible to keep the compressor running
in order to preserve the product at the correct
consistency. However, the compressor must be switched
off by acting on the timer, when about half of the product
has already been extracted.
- When extraction has been completed, turn the selector
switch to 0, open the lid and extract any residual product
using a plastic spatula.