Installation Instructions For Luminaire With Single Hinge Design; Installation Instructions For Luminaire With Multi-Hinge Design (Type I And Type Iii Light Distribution) - Emerson Appleton Mercmaster Connect Instructions D'installation

LED housing Installation
WARNING: The luminaire must be grounded as required by the National Electrical Code (Paragraph 410-21 and Article 250) or
Canadian Electrical Code (Rule 30-500 and Section 10). Verify that ground continuity has been established by using an Ohm meter or
other suitable testing equipment before energizing the luminaire. Failure to properly ground the luminaire will create an electric shock
hazard, which can cause serious injury or death.

Installation Instructions for Luminaire With Single hinge Design

1. Disconnect facility power to the electric power supply leads.
2. Feed the supply wires through the conduit entry in the mounting hood.
3. Hang the luminaire on the hinge; secure with the hinge pin.
4. Strip the individual conductors to bare wire and insert them into the proper terminal block connections. The connection points
are identified on the terminal block as: "L" = Line, "N" = Neutral, and "G" = Ground. Tighten down the terminal block screws
onto the wire to a torque of 0.6 Nm min. 0.8 Nm max.
5. Terminals marked as 'H' can be used to connect HART configuration tool.
6. Terminals marked as 'A' are for future use.
7. Luminaire requires bonding to mounting hood. Connect internal housing bond wire to GREEN ground screw in the mounting hood.
8. Orient the position of the SENSOR POD towards the center of the walkway.
9. Fold all excess supply leads and fasten them into the mounting hood with the wire tie (supplied) to avoid pinching the wires.
10. Swing the luminaire up and tightly secure with the hex nut and washer combination.
Installation Instructions for Luminaire With Multi-hinge Design
(Type I and Type III Light Distribution)
1. Disconnect facility power to the electric power supply leads.
2. Feed the supply wires through the conduit entry in the mounting hood.
3. Find the "Direction of Light" label near one of the hinges on the LED Housing.
Appleton • 1.800.621.1506 • www.appletonelec.com
fIGURE 19: WIRING COMPARTMENT
fIGURE 20: hOUSING INSTALLATION - MULTI-hINGE DESIGN
DOC000084A000 Rev. 03 MY8382 • 03-AUG-22 • Page 15 of 46