Emerson Appleton Mercmaster Connect Instructions D'installation page 17

Commissioning
Note:
The Appleton Motion Sensor and all other wireless devices should be installed only after the
Wireless Gateway has been installed and is functioning properly. Wireless devices should also be
powered up in order of proximity from the Wireless Gateway, beginning with the closest device to
the Gateway. This will result in a simpler and faster network installation.
Verify operations
Operations can be verified in below locations:
• Using the Field Communicator
• At the Gateway's integrated web interface
• Using AMS Wireless Configurator or AMS Device Manager
• Using the Connecting Lighting Application
Emerson Wireless Gateway
In the integrated web interface from the Gateway, navigate to the Explorer → Status page. This page shows whether the device
has joined the network and if it is communicating properly.
FIGURE: WIRELESS GATEWAY NETWORK SETTINGS
Appleton • 1.800.621.1506 • www.appletonelec.com DOC000084A000 Rev. 03 MY8382 • 03-AUG-22 • Page 17 of 46