Emerson Appleton Mercmaster Connect Instructions D'installation page 11

Trunnion (kPCT-75, kPCT-100)
Dimensions:
Installation:
1. Mount the trunnion hood directly to a flat surface using user-supplied hardware appropriate for the mounting surface.
Note: The trunnion has a center clearance hole for a 1/2 inch bolt and two 1/2 inch clearance holes spaced 3-1/2 inches apart on
the trunnion center line.
2. Slightly loosen the four trunnion bolts and tilt the luminaire to the desired position with your free hand.
3. Retighten the bolts to secure the luminaire in place.
4. Remove unused conduit plugs and reinstall with a corrosion-inhibiting grease, such as petroleum or soap-thickened mineral oils,
in 3 lines, spaced approximately 120 degrees apart, perpendicular to the threads on the conduit plugs.
Appleton • 1.800.621.1506 • www.appletonelec.com
LUMINAIRE WITh SMALL hEAT SINk
LUMINAIRE WITh LARGE hEAT SINk
fIGURE 11: LUMINAIRE WITh TRUNNION hOOD
CONDUIT ENTRY (5x)
fIGURE 12: TRUNNION hOOD DETAILS
DOC000084A000 Rev. 03 MY8382 • 03-AUG-22 • Page 11 of 46