Emerson Appleton Mercmaster Connect Instructions D'installation page 23

Table B-4: Advisory
Message
Capacity Denied
Database Storage Error
Configuration Alert
Driver Case Temperature Exceeded
Driver Case Humidity Exceeded
Electronics Temperature Exceeded
Device Variable Simulation Active
(1) Location of the alert in the HART command 48 Additional Status field.
Except as expressly provided by Appleton Grp, LLC (Appleton), Appleton products are intended for ultimate purchase by industrial users and for operation by persons trained and experienced in the use and maintenance of this equipment
and not for consumers or consumer use. Appleton warranties DO NOT extend to, and no reseller is authorized to extend Appleton's warranties to any consumer.
While every precaution has been taken to ensure accuracy and completeness in this manual, Appleton Grp, LLC. assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or
omissions. Specifications are subject to change without notice. The Appleton and Emerson logos are registered in the U.S. Patent and Trademark Office. All other product or service names are the property of their registered owners.
©2021 Appleton Grp, LLC. All rights reserved.
Appleton • 1.800.621.1506 • www.appletonelec.com
Additional status (1)
Byte 12:: Bit 0
Byte 0:: Bit 2
Byte 2:: Bit 6
Byte 5:: Bit 2
Byte 5:: Bit 1
Byte 5:: Bit 0
Byte 8:: Bit 0
DOC000084A000 Rev. 03 MY8382 • 03-AUG-22 • Page 23 of 46
Description
The device has failed to require all
of the necessary wireless bandwidth to
broadcast at the configured rate(s)
The device has failed to write to the data-
base memory at some time in the past.
Any data written during this time may have
been lost
The device has detected a
configuration error
The temperature recorded by the sensor
on the communication module exceeded
the configured limit.
The humidity recorded by the sensor on
the communication module exceeded the
configured limit
The temperature recorded by the sensor
on the sensor module exceeded the
configured limit
The device is in simulation mode and is
not reporting actual information