Removal Of The Filter Cartridge - Sirius S-DD3 TC EM 50 Instructions D'utilisation Et Avis De Montage

Table des Matières

Les langues disponibles

UTILISATION

This product is intended to extract fumes, fats, and steam from cooking. It has been designed and made for use

either in the suction or filter versions.

VERSION EVACUATION exterieure

The hood is equipped with an air outlet to convey smoke outwards (the flue pipe and fixing flange are not sup-

plied).

Check valve blockage

Warning: Before connecting the air exhaust hose, make sure that the check valves are free to

turn over freely.

For hoods with outside air exhaust, fit a check valve to prevent wind and returning air from

entering.

Recirculation model

If it is not possible to fit an exhaust flue for smoke and fumes to be discharged outside, it is

possible to use the recirculation model. Carbon filters are required for this type of hood. The

recycled air is discharged back into the kitchen via a pipe that conveys it out through one side

of the unit (Fig. 14 bis).

Installation must conform to the regulations in force regarding the ventilation of en-

closed environments. In particular, discharged air must not be channelled into a conduit

used for exhaust discharge or discharge from devices that operate with gas or other com-

bustible materials. The use of unused conduits is not permissible without the approval of

a qualified technician.

The product can be installed at a distance of less than 65 cm from the cook top, according

to the standard EN60335-2-31:1997.

- REMOVAL OF THE FILTER ALUMINIUM CARTRIDGE

- MOUNTING THE CARBON FILTER

The removal and fitting of the grease and carbon filters need to be carried out with the down-

draft in the open position. To open the downdraft, push the ON/1 key. Then remove the front

panel, (Fig.8). The panel will rotate forwards to make it possible to access the grease filters

panel, pushing the upper part of each side at the same time. The panel will rotate forwards to

(Fig.16). Remove the grease filters to access the carbon filters (Fig.17). The replacement of the

make it possible to access the grease filters (Fig. 16). Remove the grease filters to access the

charcoal filters has to be carried out accordinglyto the effective use of the Downdraft, and in

carbon filters (Fig. 17). The carbon filters should be changed according to the frequency of

any case at least once every 6 months.

downdraft use and in any case, once every 6 months.

Table des Matières