Kärcher MIC 26 Mode D'emploi page 39

2 Information about the vehicle
2.1 Proper use
Use this appliance only as directed in these operating in-
structions.
This machine (attachment carrier) was developed for use
on greens, to take care of landscaping and for winter ser-
vices.
– The MIC 26C device is available as a version with a
driver cabin and as a version with a protective bar. The
protective bar can be folded down, e.g. when mowing
under trees.
For safety reasons (flying stones, dust, etc. during
sweeping), the device with protective bar is not permit-
ted for work with the sweeping system.
– The appliance may only be operated on public roads if
it is equipped with the upgrade kit StVZO (optional ex
works).
– Different attachments (not included in the scope of de-
livery) can be connected to the front or the back of this
machine. Attachments that may jeopardise the safety
or stability of the machine, must not be used.
– IMPORTANT! Before connecting attachments that
were not specifically intended for this machine, please
contact your dealer to check how these attachments
should be connected and used. This is essential for the
safety of the driver and the machine as well as for pos-
sible warranty claims.
– This machine (attachment carrier) is ready to operate
when delivered. Proper treatment and maintenance in-
crease the operational safety and product life of the
machine.
– The machine can also be used as a towing vehicle
(hitch is optionally available).
– The appliance should not be used in closed rooms.
– The following applies in general: Keep highly-flamma-
ble substances away from the appliance (danger of ex-
plosion/fire).
– If not attachment is connected to the rear of the appli-
ance, you must install the balance weights on the rear.
3 General notes
Your sales outlet should be informed about any transit
damage noted when unpacking the product.
– Read and adhere to the operating instructions and
safety notes of the attachments affixed to the appli-
ance.
– Warning and information plates on the machine provide
important directions for safe operation.
– In addition to the information contained in the operating
instructions, all statutory safety and accident preven-
tion regulations must be observed.
– In these operating instructions, the terms device, appli-
ance carrier, machine and vehicle are used synony-
mously.
– The machine may only be operated on the surfaces ap-
proved by the company or its authorised representa-
tives.
2.1.1 Foreseeable misuse
Any use other than the one intended and described above
is prohibited. The user is liable for any hazards arising from
incorrect use.
The use for any other purposes than described in these in-
structions is prohibited.
Transporting persons on the vehicle, the load bed or at-
tachments is not permitted.
No changes must be performed on the vehicle.
The machine may not be used or stored in hazardous are-
as. It is not allowed to use the appliance in hazardous lo-
cations.
2.2 Centre of Gravity
Position of centre of gravity without attachments installed.
 Rear attachments and load statuses have an impact on
the vehicle's centre of gravity and thus on the driving
characteristics.
 If not attachment is connected to the rear of the appli-
ance, you must install the balance weights on the rear.
3.1 Environmental protection, REACH and
disposal of the worn out vehicle
3.1.1 Environmental protection
The packaging material can be recycled. Please
do not throw the packaging material into house-
hold waste; please send it for recycling.
Batteries, oil, fuels and similar substances
must not be released into the environment.
Please dispose of these substances via suita-
ble collection systems.
2
-
EN 39