Transit Wheels; Tires And Mounting; Possible Problems; Maintenance - Sunrise Medical EASY 200 Notice D'utilisation

Options – Transit Wheels

Transit Wheels

(7.113)
Transit wheels should be used
wherever your wheelchair would
be too wide if the rear wheels were
used (e.g., in airplanes, buses,
etc.). After the rear wheels have
been removed with the aid of the
quick-release axles, the transit
wheels can immediately be used
to continue riding. The transit
wheels are mounted so that they
are approx. 3 centimeters above
the ground when not in use. They
are thus out of the way when
riding, transporting, or when tip-
ping to pass over obstacles (e.g.,
curbs, steps, etc.).
CAUTION:
Your wheelchair does not have
any wheel locks when the transit
wheels are being used.

Tires and Mounting

Tires and Mounting (8.1)
Always make sure you that you maintain the correct tire pressure,
as this can have an effect on wheelchair performance. If the tire
pressure is too low, rolling resistance will increase, requiring more
effort to move the chair forward; low tire pressure also has a nega-
tive impact on maneuverability. If the tire pressure is too high, the
tire could burst. The correct pressure for a given tire is printed on
the surface of the tire itself. Tires can be mounted the same way as
an ordinary bicycle tire. Before installing a new inner tube, you
should always make sure that the base of the rim and the interior
of the tire are free of foreign objects. Check the pressure after
mounting or repairing a tire. It is critical to your safety and to the
wheelchair's performance that regulation air pressure be maintai-
ned and that tires be in good condition.

Possible Problems

Wheelchair pulls to one side
• Check tire pressure
• Check to make sure wheel turns easily
(bearings, axle)
• Check angles of casters
• Check to make sure both casters are making proper contact with
the ground
Casters begin to wobble (9.2)
• Check angle of casters
• Check to make sure all bolts are secure; tighten if necessary
(See the page on torque)
• Check to make sure both casters are making proper contact with
the ground
Wheelchair / Cross-tube assembly does not snap into position
in the seat saddle (9.3)
• Chair is still new, i.e., the seat or backrest upholstery is still very
stiff. This will improve with continued use.
26
EASY 200-300, max
49.1
49.2
(9.1)
Wheelchair is difficult to fold up
• Adjustable backrest upholstery is too stiff; loosen it accordingly.
Wheelchair squeaks and rattles
• Check to make sure bolts are secure; tighten if necessary (see
the page on torque).
• Apply small amount of lubrication to spots where movable parts
come in contact with one another
Wheelchair begins to wobble
• Check angle at which casters are set
• Check tire pressure
• Check to see if rear wheels are adjusted differently

Maintenance

Maintenance (9.9)
• Check the tire pressure every 4 weeks. Check all of the tires for
wear or damage.
• Check the brakes approximately every 4 weeks to make sure
that they are working properly and easy to use.
• Change tires as you would an ordinary bicycle tire.
• All of the joints that are critical to safe using your wheelchair
safely are self-locking nuts. Please check every three months to
make sure that all bolts are secure (See the page on torque).
Safety nuts should only be used once and should be replaced
after multiple uses.
• Please use only mild household cleansers when your wheelchair
is dirty. Use only soap and water when cleaning the seat uphol-
stery.
• If your wheelchair should ever get wet, please dry it after use.
• A small amount of sewing-machine oil should be applied to
quick-release axles approximately every 8 weeks. Depending on
the frequency and type of use, we recommend taking your
wheelchair to your authorized dealer every 6 months to have it
inspected by trained personnel.
CAUTION:
Sand and sea water (or salt in the winter) can damage the bea-
rings of the front and rear wheels. Clean the wheelchair
thoroughly after exposure.
Nameplates / Guarantee
Nameplates (11.1)
The nameplate is located on either the cross-tube assembly or the
transverse frame tube, as well as on the back page of the owner's
manual. The nameplate indicates the exact model designation and
other technical specifications. Please provide the following pieces
of information whenever you have to order replacement parts or to
file a claim:
• Serial number
• Order number
• Month / Year
Guarantee
You have purchased a high-quality Sopur product. As a sign of our
gratitude, we are providing you with a 5-year guarantee on all fra-
me components and for the cross-tube assembly. We are not res-
ponsible for any damage resulting from inappropriate or unprofes-
sional installation and/or repairs, neglect, wear, or from changes in
any wheelchair components caused either by the user or by third
parties. In such cases, this guarantee shall be considered null and
void.
Custom wheelchairs cannot be exchanged.
(9.5)
(9.6)
(9.7)
16.06.10 Easy200/300/max Rev.C