HumanTechnik Signolux A-2655-0 Mode D'emploi page 13

Setup for telephone signalling
Plug the end of the cable with the
transparent clip-in connector (6-pin
plug) into the socket on the underside
of the »Direct universal transmitter«.
Plug the other end into a vacant con-
nector of the telephone socket.
Important:
Please only use the telephone cable
supplied with the unit, otherwise pro-
per function cannot be guaranteed.
The »Direct universal transmitter« is
designed to be connected to an ana-
log telephone system.
If your phone system is ISDN or part
of a PBX (exchange) system, use the
»Acoustic universal transmitter« in-
stead.
Register the transmitter with the ac-
cording receivers. When setting, use
the telephone symbol.
Picking up other signals
The »Direct universal transmitter« is
able to detect various electrical sig-
nals. It then transmitts a radio signal
to all assigned »signolux«-receivers
within reach.
Socket #1 reacts to input voltage of
at least 3 volts and no more than 15
volts. It is possible to connect to either
alternating or direct current voltage.
This allows the »Direct universal
transmitter« to be connected to low-
voltage systems, like e.g. doorbell
circuits.
Proceed as follows:
Plug the connection lead into socket
#1 of the transmitter. Lay the lead to
the according doorbell or -chime.
Connect the two ends of the lead to
the according contacts of the doorbell.
Register the transmitter with the ac-
cording receivers. When setting, use
a door / visitor symbol.
Very important:
The input is only designed for the con-
nection to low-voltage circuits. The in-
put voltage must not exceed 15 V!
Never connect the thin cable to the
mains voltage (230 V ±10%).
If in doubt, seek the help of an electri-
cian.
Otherwise: Risk of fatal injury and
irreparable damage to the transmit-
ter!
Connecting alarm accessories
Connection socket #2 is intended for
the connection of alarm accessories
having a closed-circuit contact. (A
closed circuit triggers the alarm).
Therefore it is possible to connect the
»Direct universal transmitter« with
accessories like contact-floormats,
window contacts as well as switched
outputs of alarm systems.
Suitable alarm accessories:
- Alarm floor mat (A-2921-S)
Plug the cable of the alarm floor
mat directly into socket #2 of the
transmitter. Place the alarm floor
mat under the door mat or carpet.
English 13