HumanTechnik Signolux A-2655-0 Mode D'emploi page 12

Figure 3
- The plastic cover can now be taken
off, the battery compartment has
become accessible.
- Insert the 3 AAA-batteries.
Ensure the correct polarity of the
batteries. (Figure 4)
Figure 4
- Attach the plastic cover:
Lay the cover onto the housing with
approx 1 cm distance to the lower
edge. (Figure 5)
English 12
Figure 5
- Push the cover downwards until
it clicks back onto the latching. The
front cover is now in place again.
Registering the transmitter with the
receivers
The »Direct universal transmitter«
has to be registered with every
»signolux«-receiver, which is later
supposed to react to it. By doing so,
the type of signalization is also defined.
To register the transmitter, press and
hold the according receiver's function
key. The receiver's event symbols
light up in sequence.
Release the function key as soon as
the desired symbol is lit up.
Now press the function key of the »Di-
rect universal transmitter«.
Wait for approx. 20 seconds and
the test the setup by pressing the
transmitter's function key. The recei-
ver should now react, showing the
according symbol.
Up to 8 transmitters can be assigned
to a single symbol.