HumanTechnik Signolux A-2655-0 Mode D'emploi page 11

Congratulations on purchasing your
»Direct universal transmitter«.
You have chosen a modern and reli-
able system. Please read these ope-
rating instructions thoroughly. They
tell you how to set up the system
correctly and explain all the system's
features to you.
Checking the package contents
Please check if the following parts are
included in the package:
»Direct universal transmitter«
- 3 x battery type AAA
- Connection lead
- Wall mount
- User manual
- Warranty card
If any parts are missing, please im-
mediately contact your dealer or the
manufacturer directly.
Safety instructions
– Prior to putting the device into op-
eration and using it, kindly read this
manual thoroughly and in full.
– Store this operating manual in a
safe place so that it is also acces-
sible for other users at any time.
– When using power tools always fol-
low the instructions of the manufac-
turer and wear suitable protective
equipment (e.g. protective gog-
gles).
- Kindly check before starting to drill
if there are any hidden electric ca-
bles and water pipes in the walls. In
case of doubt we recommend using
a a cable detector.
Functioning principle
The »Direct universal transmitter«
picks up electrical signals by means
of a directly connected cable and in
consequence generates radio sig-
nals.
The radio signals are transmitted to all
accordingly programmed »signolux«-
receivers within range.
The receivers convert the radio sig-
nals into light-, vibration- or acoustic
signals (depending on the type of
receiver).
Setup
Inserting / replacing the batteries
To insert the 3 AAA-batteries, first re-
move the front cover in order to ac-
cess the battery compartment:
- Push the front plastic cover upwards.
A certain resistance, caused by the
latching, has to be overcome.
(Figure 3)
English 11