If the supply cord is damaged, it must be replaced by an identical
cord. If the cord is not removable, return the drive to after sales
department to avoid a hazard.
To reduce the risk of electric shock, this equipment must have
a proper grounding. Some Drives versions are supplied with a
grounding type plug, that has a third (grounding) pin. This plug
will only fit into a grounding type outlet. If the plug does not fit
into the outlet, contact a qualified electrician to install the proper
outlet. Do not change the plug in any way.
The actuating member of a biased-off switch is to be located wit-
hin direct sight of the driven part but away from moving parts. It
is to be installed at a minimum height of 1,5 m and not accessible
to the public.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Important safety instructions. It is important for the
safety of persons to follow these instructions.
Save these instructions.
-Your installer should inform you of any maintenance required.
Do not allow children to play with fixed controls. Keep remote
controls away from children.
Watch the driveised installation while it is moving and keep
people away until the driveised installation is fully extended.
The drive shall be disconnected from its power source during
cleaning, maintenance and when replacing parts.
Frequently examine the installation for imbalance and signs of
wear or damage to cables and springs. Do not use if repair or
adjustment is necessary.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved.
Cleaning and user maintenance shall not be made by children
without supervision.
Children shall not play with the appliance.
Before installing the drive, remove any unnecessary cords and
disable any equipment not needed for powered operation.
If the drive is fitted with a manual release, install its actuating
member at a height less than 1,8 m.
LpA ≤70 dB(A).
SOMFY ACTIVITES SA, Société Anonyme, F-74300 CLUSES as manufacturer hereby declares that
the drive covered by these instructions when marked for input voltage 230V~50Hz and used
as intended according to these instructions, is in compliance with the essential requirements
of the applicable European Directives and in particular of the Machinery Directive 2006/42/EC,
and the Radio Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at www.somfy.com/ce.
Antoine Creze, Approval manager, acting on behalf of Activity director, Cluses, 06/2017
Safety warning!
For the illustration, see page 122.
Copyright © 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved
Caution!
Information
.
EN
3