System Components - Integra EPS ULTRAFLEX Instructions D'installation

ULTRAFLEX
1.3

System components

The INTEGRA system consists of the following components:
ELECTRONIC STEERING SYSTEM: through the electronic steering system, the system converts the steer-
1
ing wheel rotation into digital signals reaching the control unit by means of the communication network.
ELECTROHYDRAULIC CONTROL UNIT: thanks to the electrohydraulic control unit, the system converts the
2
signals received from the steering system enabling the check of the hydraulic cylinders on the boat.
The pump is enabled by a 12 V in cc engine and several valves inside the control unit allow managing the
whole steering system.
CONTROL PANEL: the control panel, positioned close to the steering station, shows the system status
3
(including faults or error messages) and it allows making all the necessary settings to let the user better
steer the boat .
BCM: The BCM control module manages the entire communication of the components thanks to a CAN bus
4
network.
5 UC120 CYLINDER: The INTEGRA system is based on the use of a UC120E electronic cylinder combined, in
case of several engines, with a UC120P-OBF hydraulic cylinder and with coupling bars.
The UC120E cylinder is equipped with an integrated position sensor allowing communicating continuously
the cylinder position. This model is only available in the STARBOARD version.
For each configuration, it is necessary to use a UC120E cylinder.
The UC120P-OBF cylinder has the same features of the E version but without position sensor.
This model is only available in the PORT version. This model can be used, always combined with an E version
cylinder, for all configurations with several engines.
4
3
2
Installation instructions
1
INTEGRA SYSTEM
5
page 9
of 131