System; Steering - Integra EPS ULTRAFLEX Instructions D'installation

ULTRAFLEX
4.3.1.1

System

SELECT TYPE
From the "SELECT TYPE" menu select INTEGRA EPS.
SELECT NUMBER OF
DEVICES
From the "SELECT NUMBER OF DEVICES" menu select the type and quantity of the available devices (from 1 to 4).
4.3.1.2

Steering

CONFIGURATION
From the "CONFIGURATION" menu select "ENGINE WEDGE ANGLE" to set the engine inclination (from 1 to 10).
PURGE CYLINDERS
Access the "PURGE CYLINDERS" function during the system bleeding (see paragraph 3.6.1).
In the case of single cylinder, set to "ON" the STBD cylinder bleeding.
In the case of double cylinder, set to "ON" the bleeding of both cylinders.
Select "CLEAR PURGE MODE" to disable the bleeding modes on both cylinders.
CALIBRATE CYLINDERS
From the "CALIBRATE CYLINDERS" function select the cylinder to be calibrated.
WARNING
When this function is turned ON, the system enables the movement of the cylinder/s.
Ensure that there are no persons or objects in the engine area and that the engines can move freely without
obstacles
Select "CLEAR CALIBRATE MODE" to exit the calibration mode.
ALIGN RUDDERS
The "ALIGN RUDDERS" function allows setting the angle of inclination of each engine, defining its parallelism,
convergency and divergence.
The values that can be selected for each setting can go from -10 to +10.
Installation instructions
page 35
INTEGRA SYSTEM
of 131