Integra EPS ULTRAFLEX Instructions D'installation page 28

ULTRAFLEX
CEPS CONFIGURATION
This configuration is based on the use of two UC120E cylinders (see the corresponding manual) to install one
(1) on the STARBOARD side and the other one (2) on the PORT side interchangeably.
NOTICE
After establishing the installation side of each cylinder, to identify correctly the corresponding
CAN connections, it is necessary to identify the STARBOARD side connection with the GREEN
adhesive tape and the PORT one with the RED adhesive tape.
2
NOTICE
In case the electric cable of the cylinder sensor is not long enough to reach the four-way connection point, it is
possible to use a CAN extension.
NOTICE
If necessary, use a 3 metre extension cable, available on request.
page 28
of 131 -
INTEGRA SYSTEM
PORT
STRB.
Installation instructions
1
→
STARBOARD
→
PORT