Periodical Operations; Steering Wheel Disassembly - Integra EPS ULTRAFLEX Instructions D'installation

ULTRAFLEX

5.1.3 Periodical operations

The periodical maintenance must be carried out by specialized operators.
All the points referred to in paragraph 5.1.2
Fill and bleed the system as described in this manual in paragraph 3.6.
Check the seal of all the connections and of the fastening devices in the whole system. If necessary, tight-
en to correct the tightening torques as indicated.
Check the absence of mechanical backlash or the inaccuracy of the steering wheel during the steering, If
necessary,correct as described in paragraph 4.3.
Check possible damages or deterioration on the hydraulic hoses.
Check possible damages or deterioration on the electrical cables of the system.
Check of the correct insertion and/or tightening of all connectors located on the system. When checking
the electric cables, make sure that the interconnections have not been damaged while handling them.
Check that the ground connections have no surface oxidation. In that case, we recommend using sprays or
common products to protect and preserve the electric contacts
Check of the components fastening the system
Check the absence of corrosion or damage on the system components.
Check Silent Block integrity.

5.2 Steering wheel disassembly

To remove the steering wheel from the shaft, use a suitable extractor.
WARNING
Do not use a hammer or other tools that could seriously damage the pump.
page 38
of 131 -
INTEGRA SYSTEM
Installation instructions