Nmea 2000 Network Prearrangement - Integra EPS ULTRAFLEX Instructions D'installation

ULTRAFLEX

3.5.4 NMEA 2000 network prearrangement

If the boat is equipped with a NMEA 2000 network,
it is necessary to add two union tees (1) for the
control panel connection (see paragraph 2.5.4)
and for the BCM connection (see paragraph 2.5.6).
NOTICE
For the correct system operation, it is advisable
to connect the RPM and GPS message cables. To
to this, use union tees (3) and (4)
If, on the contrary, the boat is not equipped with
a NMEA 2000 network, it is necessary to create a
line made of a union tee (5) for the power supply,
a union tee (1) for the control unit connection (see
paragraph 2.5.4) and a union tee (2) for the BCM
connection (see paragraph 2.5.6).
NOTICE
At the end of the connections use a terminal plug COD. 76843H (6).
NMEA 2000
2
3
NMEA 2000
5
2
6
INTEGRA SYSTEM
Installation instructions
1
4
6
1
+
FUSE 3A
+
+
-
page 23
of 131