Tools Required - R&G CP0337BL Mode D'emploi

LEGEND
ITEM 1 = CRASH PROTECTOR CAPS (BC JV1000) (x2).
ITEM 2 = CRASH PROTECTOR (XLB JV1000 with CS JV1000) (x1).
ITEM 3 = SPACER (S0064) (40mm long) (x1).
ITEM 4 = SPACER (S0217) (35.5mm long) (x1).
ITEM 5 = CRASH PROTECTOR (SB JV1000 with CS JV1000) (x1).
ITEM 6 = M10x1.25x140mm LONG HEX HEAD BOLT (x1).
ITEM 7 = LOCK-WASHERS (LW0001) (x2).
ITEM 8 = M10 WASHERS (x2).
ITEM 9 = BOBBIN CAP REMOVAL TOOL (x1).
ITEM 10 = M10x1.25x150mm LONG HEX HEAD BOLT (x1).
Please note that in cases where kits are packed with rubber washers holding the components
onto the bolt – the rubber washers should be thrown away!
TOWARDS REAR
OF BIKE
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301

TOOLS REQUIRED


Socket set to include 14 & 17mm socket and wrench.

14mm spanner.

T50 Torx socket.

50mm diameter hole cutter and/or Dremel type tool.

Torque wrench (up to 40N/m).
PICTURE C
GENERAL TORQUE SETTINGS
M4 BOLT = 8Nm
M5 BOLT = 12Nm
M6 BOLT = 15Nm
M8 BOLT = 20Nm
M10 BOLT = 40Nm
M12 NYLOC NUT = 40Nm
R&G Racing
www.rg-racing.com Email:
CP0337
TOWARDS FRONT
OF BIKE
info@rg-racing.com