Installing The Batteries - Cresta Care DTX690 Mode D'emploi

•
5 weather forecast icons: SUNNY, PARTLY CLOUDY, CLOUDY, RAIN CHANCE, STORM
CHANCE
•
Barometer and bar and data of 12 hours history for air pressure
•
Indoor /outdoor temperature and humidity with trend
•
Max./min. of temperature and humidity
•
Thermometer measuring range inside:°C to +50 °C , outside -20°C~60 °C
•
Temperature display elective in °C or °F
•
Temperature alert for indoor and outdoor
•
Living space humidity
•
Moon phase
•
Wind speed in mph /kmh， wind speed 0~256kmh
•
Wind direction in 16 directions
•
Rainfall in mm and inch and display of 1hour, 24hour, Total.
Rain volum： 0~999.9MM
•
·Low battery indication
•
Blue background illumination LED.
•
Main unit batteries: 3 x AAA, LR03, 1.5V
Outdoor sensor:
•
Frequency: 868 MHz
•
Transmission range: 100 meters in open area.
** Actual distance may be varied depending upon the enviroment, it will be
shortened if with interference ,such as concrete wall etc.
•
Batteries: 2 x AA, LR06 1.5V
INSTALLATION

Installing the Batteries

•
Open the main unit battery cover located at the back of the unit and insert 3XAAA
batteries into the battery compartment and close the battery cover.
•
Connect base stand to the unit.
•
Insert 2xAA, LR06,1.5V batteries into transmitter and observe the red LED light
flashing.
•
Connect the attached cables for outdoor sensor : 1.cable from wind speed sensor
insert into the socket of wind direction sensor 2. cable from wind direction and
cable from rain sensors to the corresponding sockets of the thermo-hygro sensor by
clicking them into place. Make sure that rain and wind cables are connected to the
correct sockets with RAIN , WIND marks.