Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Item
name
1
Weather forecast
2
Living space humidity
3
Indoor humidity trend
4
Indoor low battery
5
Rainfall
6
Air Pressure
7
Wind direction
8
Date
9
Wind speed
10 Month
11 Day of week
12 Moon Phase
13 Dual alarm
14 Time
Top View:
A=MODE B=ALARM C=ALERT D=SNOOZE/LIGHT E=UP F=DOWN
INITIAL OPERATION
•
After inserting the batteries, the main unit will connect with the outdoor sensor by RF
signal.
The RF signal symbol at the OUT area will flash.
•
This process takes about 3 minutes. Then the display shows the outdoor temperature
/humidity/wind speed/wind direction/rainfall, in case of failure of reception , pls
press "ALARM "for more than 3 seconds to receive again.
•
the automatic receiving of the DCF radio signal begins after 3 minutes of outdoor RF
reception.
This RCC reception process is going on,the flashing symbol "radio tower" appears in
•
the time display area at the same time.
Once radio signal receiving is successful, the display shows the symbol "radio
•
tower" continuously. The flashing stops
If, due to bad reception, or no RCC automatic time reception is possible, follow the
steps below manually.
MANUAL TIME SET UP.
Please also follow the steps to choose some setting, such as 12/24hour, time zone,
language, etc.
Item
15 RCC symbol
16 Summer time
17 Outdoor low battery
18 Outdoor humidity
19 Outdoor humidity trend
20 Indoor humidity
21 Outdoor Temperature
22 Outdoor temperature Alert
23 RF symbol
24 Indoor temperature Alert
25 Outdoor temperature trend
26 Indoor temperature
27 Indoor temperature trend
name
Publicité
Table des Matières
