Cresta Care DTX690 Mode D'emploi page 24

Press and hold key "MODE" for 3 seconds.
•
The 24 hour flashing. Use "UP" and "DOWN" to select 12/24Hr
•
Press "MODE" to confirm.
•
The display for the time zone is flashing. Use "UP and "DOWN " to select the time zone
•
(-12 to +12).
Press "MODE" to confirm.
•
The DM/MD flashing. Use "UP" and "DOWN" to select
•
Press "MODE" to confirm.
•
The display for the year is flashing. Use "UP" and "DOWN" to select the year.
•
Press "MODE" to confirm.
•
The display for the month is flashing. Use "UP" and "DOWN" to select the month.
•
Press "MODE" to confirm.
•
The display for the date is flashing. Use "UP" and "DOWN" to select the date.
•
Press "MODE" to confirm.
•
The display for the hour is flashing. Use "UP" and "DOWN" to select the hour.
•
Press "MODE" to confirm.
•
The display for the minutes is flashing. Use "UP" and "DOWN" to select the minutes..
•
Press "MODE" to confirm.
•
The language selection for the display of the weekday is flashing. Use "UP" and
•
"DOWN" to select the language.
Press "MODE" to confirm
•
The C/F for temperature flashing. Use "UP" and "DOWN" to select .
•
Press "MODE" to confirm.
•
The hpa/inhg for air pressure flashing. Use "UP" and "DOWN" to select .
•
Press "MODE" to confirm.
•
The mm/inch for rainfall and kmh/mph flashing. Use "UP" and "DOWN" to select .
•
Press "MODE" to confirm.
•
INFORMATION:
•
The clock automatically changes from set-up mode to time display mode if no keys
are pressed for 20 seconds.
•
Explanation for the time zone display:
You can manually adjust the clock to the time zone of a country (up to 1500km
distance
to Frankfurt/Main) where the clock receives the DCF signal but where the actual
time
differs from the time received.
If, e.g. the time in a given country is 1 hour ahead of the German time, set the time
zone
display to 01. The clock is now DCF controlled but the time is one hour ahead.
DAILY ALARM SET UP
Press "MODE" to switch from time display to A1 display
•
Press and hold the key "MODE" for 3 seconds, the flashing alarm time is shown
•
The hour display of the alarm time is flashing. Use "UP" and "DOWN" to select the
•
hour.
Press "MODE" to confirm.
Then follow the minutes. Use "UP" and "DOWN" to select the minutes,
•
Press "MODE" to confirm.
•
The same setting as for A2.