Connecting The Air Hose; Connecting The Ac Adapter; Wireless Function - AND UA-651CNBLE Manuel D'instructions

Using the Monitor

Connecting the Air Hose

Insert the air connector plug into the air
socket firmly.

Connecting the AC Adapter

Insert the AC adapter plug into
the DC jack. Then, insert the
AC adapter into an electrical outlet.
The AC adapter part # TB-233,
is sold separately.
• Use the specified AC adapter.
(See Technical Data)
• When disconnecting the AC adapter from the electrical outlet, grasp
and pull the AC adapter body out of the outlet.
• When disconnecting the AC adapter plug from the blood pressure
monitor, grasp and pull the AC adapter plug our of the monitor.

Wireless Function

• In the unlikely event that this monitor causes radio wave interference
to a different wireless station, change the location where this monitor
is used or stop use immediately.
• Be sure to use in a location where visibility between the two
devices that you want to connect is good. The connection distance
is reduced by the structure of buildings or other obstructions. In
particular, connection may be impossible when devices are used on
either side of reinforced concrete.
• Do not use Bluetooth
other wireless devices, near devices that emit radio waves such as
microwaves, in locations where there are many obstructions, or in
other locations where signal strength is weak. Doing so may result
in frequent loss of connection, very slow communication speeds
and errors.
connection in the range of a wireless LAN or
®
Air Hose
Air Connector Plug
Air Socket
AC adapter Plug
DC Jack
E-10