Fitting The Additional Handle; Fitting/Changing The Roughing/ Cutting Disc - Parkside PWS 230 C3 Traduction Du Mode D'emploi D'origine

Fitting the additional handle

CAUTION!
► For safety reasons, this appliance may only
be used with the additional handle
Failure to do this can lead to serious injury.
The additional handle
onto the left or the right depending on the job
at hand.
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when chang-
ing cutting/rough grinding discs. Roughing and
cutting discs become very hot. Allow them to cool
down completely before touching them.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the hole must fit the
mounting flange without any play. Do not use a
reducer or adapter.
■ Check the roughing/cutting disc. It should not
be damaged or damp, and it should have no
cracks. Otherwise, it could break during use
and cause injuries.
NOTE
► Use only discs which are free of dirt.
■ Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
■ RISK OF INJURY! Press the spindle locking
button only when the mounting spindle
at a complete standstill.
♦ Press the spindle locking button
spindle.
♦ Undo the clamping nut
mounting spanner
♦ Place the rough grinding or cutting disc with the
label side towards the appliance on the mount-
ing flange .
PWS 230 C3
.
can be screwed
to lock the
using the two-hole
(see fig D).
♦ Then replace the clamping nut
side facing up on the mounting spindle
With thin grinding discs (see fig. 1):
♦ The collar of the clamping nut
so that a thin grinding disc can be fitted safely.
Fig. 1
♦ Press the spindle locking button
spindle.
♦ Tighten the clamping nut
mounting spanner
With thick grinding discs (see fig. 2):
Fig. 2
The collar of the clamping nut
so that a thick grinding disk can be fitted securely
onto the mounting spindle
♦ Lock the mounting spindle
is
♦ Tighten the clamping nut
rection using the two-hole mounting spanner
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
♦ For safety's sake run the appliance at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.
with the raised
.
faces upwards
≤ 3,2 mm
to lock the
using the two-hole
.
> 3,2 mm
faces downwards
.
.
in a clockwise di-
GB │ IE │
27
12
.
■