Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Adjusting The Blade Guard; Fitting The Additional Handle - Parkside PWSA 20-Li B3 Traduction Des Instructions D'origine

Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦ Allow the battery pack
handle.
Removing the battery pack:
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Adjusting the blade guard

WARNING! RISK OF INJURY
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
RISK OF INJURY
► Always use the angle grinder with the
blade guard . The blade guard should be
installed securely. Set it so that the highest
possible degree of safety is achieved, i.e.
the smallest possible part of the grinding
disc is exposed to the operator. The blade
guard is designed to protect the operator
from fragments and accidental contact with
the grinding tool.
PWSA 20-Li B3
to click into the
and remove the
to
as follows:
RISK OF INJURY
► Make sure that the blade guard
at at least the same angle as the additional
handle (see fig. B). Otherwise, you could
injure yourself on the roughing disc or cutting
disc.
♦ Turn the blade guard
(working position). Make sure that the blade
guard is positioned in such a way that the
blade guard fixture
5 bulges on the blade guard
(fold-out page).
♦ Ensure that the blade guard fixture
seated in the respective bulge

Fitting the additional handle

CAUTION!
► For safety reasons, this appliance may only
be used with the additional handle
ure to do so can lead to serious injury. The
additional handle
the left, the right or the top, depending on the
job at hand.
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when changing
cutting/rough grinding discs.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the hole must fit the
attachment flange without any play. Do not use
a reducer or adapter.
NOTE
► Use only discs which are free of dirt.
■ Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
■ RISK OF INJURY! Press the spindle locking
button only when the attachment spindle
is at a complete standstill.
♦ Press the spindle locking button
motor.
is fitted
to the required position
lies over one of the
(see Fig. E
is firmly
.
. Fail-
can be screwed onto
to lock the
GB │ IE │ NI │
11 ■