Dust Box; Reducer; Use; Adjusting The Additional Handle - Parkside ALX260CARB Traduction Des Instructions D'origine

Dust box

Connecting
♦ Slide the dust box
as the stop .
Removal
♦ Pull the dust box
NOTE
► To achieve optimum dust extraction, the dust
box should be emptied regularly .
♦ To do this, remove the dust box
appliance as described above . Open the dust
box by pulling on the tab
the lid . Clean both parts thoroughly by tapping .

Reducer

Connecting
♦ Push the reducer for external extraction appli-
ances into the adapter fitting
♦ Push the hose from a suitable dust extraction
appliance (e .g . a workshop vacuum cleaner)
onto the reducer for external extraction appli-
ances .
Removal
♦ Pull the hose of the vacuum cleaner off the re-
ducer for external extraction appliances
♦ Remove the reducer
PAEXS 20-Li A1
onto the appliance as far
off the appliance .
from the
and then removing
.
.

Use

NOTE
► Always switch on the appliance before contact
with the material and then apply the tool to the
workpiece .

Adjusting the additional handle

You can adjust the additional handle
different positions .
♦ To reposition the additional handle
the screw
♦ Move the additional handle
position .
♦ Retighten the screw

Switching on and off

Switching the appliance on
♦ Move the ON/OFF switch
Switching the appliance off
♦ Move the ON/OFF switch

Setting the rotational speed

♦ Adjust the speed setting wheel
between 1 and 6 .

Working procedures

.
■ Switch the appliance on before applying it to
the workpiece .
■ Apply minimal pressure when working .
■ Work at a constant speed .
■ Change the sanding sheets regularly .
■ Never use the same sanding sheet for sanding
different materials (e .g . wood followed by
metal) . Optimum sanding results can only be
achieved by using clean sanding sheets .
.
to the required
.
to the "I" position .
to the "0" position .
to a position
GB │ IE │ NI
to several
undo
│ 9 ■